Rotor arm - renewal

Ignition systems / Rotor arm - renewal

Removal
1 With reference to Section 4, remove the distributor cap and its screening shield (where applicable).

2 Pull the rotor arm from the end of the distributor shaft (refer to illustration 4.7a).

3 Inspect the distributor shaft contacts and clean them if necessary, using contact cleaning solution - do not use abrasive paper or a wire brush as this will accelerate contact wear.

Refitting
4 Refitting is a reversal of removal - ensure that the rotor arm alignment lug engages with the recess in the distributor shaft, before refitting the distributor cap.