Handbrake lever - removal and refitting

Braking system / Handbrake lever - removal and refitting

Removal
1 Remove the plastic cover from the lever and fully release the lever.

2 Where necessary remove the rear section of the centre console with reference to Chapter 11.

3 Pull back the carpet, then unscrew the adjusting nut from the front end of the handbrake cable.

4 Unscrew the mounting bolts and lift the lever from the floor at the same time sliding the pin from the cable adjustment end fitting.

Refitting
5 Refitting is a reversal of the removal procedure, but finally adjust the handbrake as described in Section 14.