Boot lid lock components - removal and refitting

Bodywork and fittings / Boot lid lock components - removal and refitting

Removal
Boot lid lock
1 Open up the boot, then undo the lock retaining screws. Remove the lock, and detach it from the link rod as it is withdrawn.

Recover the plastic cap.

Boot lid lock cylinder
2 Where necessary remove the trim/cover from the inside of the boot for access to the rear of the lock.

3 Unclip the link rod from the lock cylinder.

4 Undo the two retaining screws and remove the lock cylinder assembly from the boot lid.

Recover the lock cylinder sealing ring.

5 It is not possible to separate the cylinder from the assembly.’
6 Inspect the sealing ring for signs of wear or damage and renew if necessary.

Refitting
Boot lid lock
7 Attach the link rod, then seat the lock and plastic cap in the boot lid and securely tighten its retaining bolts.

Boot lid lock cylinder
8 Fit the sealing ring to the lock cylinder assembly. Insert the assembly into the boot lid and refit the retaining screws tightening them securely.

9 Clip the link rod on the lock cylinder and where necessary refit the trim/cover.